Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

MALFUNCTION INDICATOR LIGHT

<< < (2/2)

xman13:

--- Quote from: Mr_Brasso on April 19, 2011, 11:05:44 PM ---Sorry for hijacking this thread.

Just this evening, halfway along the AYE, suddenly my Malfunction Indicator Light came up as well....the car then experienced very slow pickup, rpm stuck at 2000, speed at 60km/h. Need to floor the accelerator to gather speed....I quickly filtered to the left lane and off/ on the engine and its ok again.... Anybody got this problem before?

I did my 70k servicing just last week at Autosaver.

Not sure whether to go Tan Chong or Autosaver to check out the problem...

--- End quote ---
Mine was oxygen sensor issue. All seems fine now after the replacement....did the replacement at Autosaver abt SGD $250 with labour.

hammer99:
I also had faulty O2 sensor last year, change at TC, also $250 inclusive labour and GST

Mr_Brasso:
went Autosaver Kaki Bukit to check. The error code is P2138.
they advised me to remove the drive throttle controller which I have installed as it might have 'short' my accelerator sensor.
I have since removed it and so far its ok...

Navigation

[0] Message Index

[*] Previous page