Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

Replacement of door molding?

<< < (2/2)

monokoro:
Wanted to change mine as well. Right side rear passenger.

Notice the Malaysian version Latio window molding is chrome...maybe can 'upgrade' :)

Anaconda:

--- Quote from: valles on December 03, 2011, 06:03:51 PM ---Hi folks,

Just noticed today that both my driver and front passenger's outside door molding is a bit jugged out and it seems bended outwards. Hence wondering where can I get it replaced?


Thanks.

--- End quote ---

About jugged out maybe not sit in properly in the door groove.  Check under the rubber.  Mine was likewise, I use small screwdriver to slowly pushback into the groove, now okay. All rubbers aligned and sitting Swee Swee. 

Anaconda:
I also apply Armorall to prevent drying and cracking. My car 6.5 years Liao, rubbers all still in good condition. 

IvanL:
I noticed that my front passenger side molding is coming off abit at the end part.

What should I do ? :confused1:

Where can I buy to replace it?

bs:
Hi all,

You can get it from Mandarin Auto at:
458 Tagore Industrial Avenue
Singapore 787827

Per piece abt 60+. Installation not provided. But, it's rather easy. Pull out the old one and then install the new one. Only for the back passenger door moulding u need to secure with the screw.

Navigation

[0] Message Index

[*] Previous page