Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio
Air con problem
IvanL:
That would be me.. My entire driver side was always wet beneath the car mat...
papajo82:
--- Quote from: dsrio on February 07, 2013, 08:54:40 PM ---think one of bro here experiene before, its due to the water tray at cooling coil, check if its leaking.
did you ever change your cooling coil at outside workshop?
i realise when i was changing my cooiling coil at kelvin workshop that the previous workshop(located at toh guan) that replaced my cooling coil actually cut the water tray to save time when replacing my cooling coil, they then used tape to stick it back :nonod:. i was lucky it never leak.
kelvin helped to patch up my water tray with silicone as thee was no spare water tray avaliable at that time, lucky for me.
--- End quote ---
Yup. Replaced my car cooling coil at Mark Cool few months ago :mad: :mad:. Will it be a safety problem? If not, will let it be... I stick a cloth there to absorb the water.
kelvin:
--- Quote from: papajo82 on February 08, 2013, 11:23:13 AM ---Yup. Replaced my car cooling coil at Mark Cool few months ago :mad: :mad:. Will it be a safety problem? If not, will let it be... I stick a cloth there to absorb the water.
--- End quote ---
no safety issue but ur undercarriage will get rusty after sometime and worst of all,ur cabin will be very smelly after parking under hot sun.... :crycry:
better get it fixed.many of my customers got this problem after doing their cooling coil else where.... :crying:
latiowner:
Anyone experience aircon not so cold after changing compressor? I used to set my aircon temp around 23 or 21 deg. But after changing compressor, even at at 20 deg, the aircon not as cold as before.....
edwardtkh:
--- Quote from: latiowner on March 01, 2013, 12:15:20 PM ---Anyone experience aircon not so cold after changing compressor? I used to set my aircon temp around 23 or 21 deg. But after changing compressor, even at at 20 deg, the aircon not as cold as before.....
--- End quote ---
where u change the comperssor? Is it original part?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version