Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

High rpm when in low speed

<< < (4/4)

alvinlee:
I've installed e-throttle and set it at EC mode.. From 0km/h to 40km/h my rpm is roughly at 1600-1800rpm... 40km/h to 80km/h rpm is roughly at 1800-2000-2100rpm.. Sometimes when doing 100km/h rpm is 2000-2200rpm.. If I would to pick up and maintain at 110-120km/h my rpm would be 2200-2400rpm.. All this reading is with e e-throttle set to EC mode..

desleyhan:

--- Quote from: alvinlee on March 20, 2013, 04:08:59 PM ---I've installed e-throttle and set it at EC mode.. From 0km/h to 40km/h my rpm is roughly at 1600-1800rpm... 40km/h to 80km/h rpm is roughly at 1800-2000-2100rpm.. Sometimes when doing 100km/h rpm is 2000-2200rpm.. If I would to pick up and maintain at 110-120km/h my rpm would be 2200-2400rpm.. All this reading is with e e-throttle set to EC mode..

--- End quote ---

Hi Alvin, Pardon me for being a noob .... I'm driving a Sedan Latio 1.5LT 2006 ... how do I install e-throttle and set EC mode? How much will it cost?

CustomGolf:

--- Quote from: cutelmo on January 11, 2013, 10:46:35 AM ---Hi ckmckm, I'm driving a 4AT sedan. Not CVT.

Whether in the morning or afternoon, the result still the same.
From low speed to about 40km/h, hit 1.8K rpm.
But reach 50km/h, back to about 1.6K rpm.

--- End quote ---

I believe this is known as overdrive in the auto box. when you're still accelerating, your torque converter will be on normal mode and once your reach a higher speed, when there is lesser load on your torque converter, it switches into overdrive mode. This is when the torque converter locks up and becomes more efficient but only on highways and low load situations. Anyone with a better explaination, please.

alvinlee:
Hi Desleyhan, sorry for e late reply. I got my device at defu lane one of the car workshop. I'm not so sure how to set as it was setup by my friend. But it's quite simple. There's a connector at e acceleration pedal. Just bypass it with e device and connect the power (the port whr they reset ecu). Power up the car(do not start engine) and ur device. Then u will need to set e device by stepping e acceleration pedal fully. I think u will hear a beep sound. Then u are good to go. Hope this can help u. (If not , u can ask e guy at e workshop to setup for u)

Navigation

[0] Message Index

[*] Previous page