Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio
Drive mode - D, D1, D2
ashocker:
Erm, just wondering, coz the menu says to press brakes before changing gear - what about changing between the various D modes - do I have to brake to a complete stop before I can change between the different D modes? :unsure:
CustomGolf:
--- Quote from: ashocker on July 05, 2008, 04:43:44 PM ---Erm, just wondering, coz the menu says to press brakes before changing gear - what about changing between the various D modes - do I have to brake to a complete stop before I can change between the different D modes? :unsure:
--- End quote ---
That should be meant for when you are shifting out of P or N.
Silver:
--- Quote from: ashocker on July 05, 2008, 04:43:44 PM ---Erm, just wondering, coz the menu says to press brakes before changing gear - what about changing between the various D modes - do I have to brake to a complete stop before I can change between the different D modes? :unsure:
--- End quote ---
you only need to depress the foot brake pedal (and push button A - the top button on the right hand side of the gear selector lever) when you change from Park to Reverse
you do not have to be at complete stop when you shift down to lower gear
if you check the manual, there are speed limits whereby you must not change to lower gear otherwise engine may over-rev and cause engine damage
Position 2 is 100 km/h
Position 1 is 55 km/h
note : when you change from position 2 to position 1, you will need to push the button A
if not sure, you can read pages 5-9 to 5-12 of the manual (Printing : March 2009 (09) version)
hope these will help you
CustomGolf:
--- Quote from: mindman on July 05, 2008, 02:43:41 PM ---Use sparingly . OD consumed lot of fuel
cheers
--- End quote ---
If used correctly it should reduce your FC, if you are merging and do not have enough power to merge properly, you'll need to slow down and later got tp pick up speed again, I believe this will use more petrol than if you merge at a higher speed thus reaching crusing speed at a shorter time.
darrylker:
--- Quote from: Silver on July 05, 2008, 05:35:34 PM ---
you only need to depress the foot brake pedal (and push button A - the top button on the right hand side of the gear selector lever) when you change from Park to Reverse
you do not have to be at complete stop when you shift down to lower gear
if you check the manual, there are speed limits whereby you must not change to lower gear otherwise engine may over-rev and cause engine damage
Position 2 is 100 km/h
Position 1 is 55 km/h
note : when you change from position 2 to position 1, you will need to push the button A
if not sure, you can read pages 5-9 to 5-12 of the manual (Printing : March 2009 (09) version)
hope these will help you
--- End quote ---
Hi bro, this info regarding Position 2 & 1 really useful for me...did'nt know that there's speed limit for D2 & D1 as this is my 1st auto car...as you may guess, never flip my manual :scared:... Thanks for your tip! ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version