Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

Mileage Needle dropping too fast

<< < (3/20) > >>

velvis:
Thanks for the reply. So what should i suppose to do in order to get at least 400km? it that ok if me and my girlfriend are sharing the car? Can the ECU handle two person driving pattern?

wave:
dun always ram your car lor....
my rpm normally stays within 2000 rpm....  :bleh:
if yours is a CVT also no point ramming....
better to let your car gradually speed up....

lation:
Thanks for all the replies here. I will monitor it again. I usually only drive on highways. Could it be also due to i am still on mineral oil? Think i will highlight to TC when i am going for the 3rd servicing.

bulleth9:
Hi Lation,

I had a same issue when I had my Latio Sport CVT 16inch rims after 2nd service1 (1000 km), guess its the mineral engine oil TCM provides for free, i was getting around 10km/l too.

I brought my own mineral oil for the 5000km servicing and it help slightly as i was using SAE40 oil.

After 10000km changed to synthetic oil after reading all the posts hear and it help jumped to around 12km/l  :thumbsup:
That is what my SE mentioned after i collected my car, it will around 12km/l after 10,000km.

Tried VPower and my latio is able to reach about 13km/l after 2 full tanks.

So just hang in there till you reach the milestone.

Bulleth9

liewks:
Could it be possible that TC mechanics leave the engine running for extended periods while performing servicing tasks? It has happened to me before. Returns to normal the next tank.

BTW, TC usually adjust tyre pressures to ~200kPa after service. May want to bring that back up to at least the recommended levels.

Navigation

[0] Message Index

[#] Next page

[*] Previous page