Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio
Rubber for lock/unlock button on doors
clarence:
I believe Vortex suggested blu tac as a temporary solution to prevent water from entering.
vortex:
--- Quote from: Jazz on February 06, 2009, 10:28:22 PM ---But blue tack will deform after you pressed it.
--- End quote ---
Ya this is only to prevent water to get in. So you may have to press the button from the passenger door or boot.
Sometimes I press the button from the boot as I walk towards my car from its back.
NSman:
laddat hor, i perfer power ranger stickers, atleast it will not stuck inside the hole... :bleh:
Ender:
You can try using rubber from those strips for door mold. Use pen knife to cut out and shape it into the same shape as the door lock/unlock button.
Jazz:
--- Quote from: NSman on February 07, 2009, 11:40:06 AM ---laddat hor, i perfer power ranger stickers, atleast it will not stuck inside the hole... :bleh:
--- End quote ---
look like handyplas ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version