Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

ABS lighted up

<< < (2/2)

kanzo:
 get your mechanic to check the speed sensor at your wheels. Unplug the connection n clean with contact cleaner. Maybe ur speed sensor dirty..

If not u can use Obd2 check the error code..another common problem is check ur ecu grounding wire maybe connection loose will affect the close loop signal so will show error for ABS..Just tighten the screw.. :)

kanzo:

--- Quote from: latioboy91 on November 11, 2009, 10:59:17 PM ---after car wash ur brakes still wet den u brake hard den ABS light on.

Or, the lady who dried your car was too hawt and she
 had D cups so your car steam and high, then need ABS to control!  :yehyeh: :yehyeh:

--- End quote ---

ah boy, next time ur car haf problem n u ask for help online , everyone tell u ur car horny n steam.. How would u feel?! If u wan to joke n bullshit around u can try www.boliaokinna.com

gary:
might be brake pad worn out?

rontan:
Lighted ABS lighted up means ABS braking will not be activated when required, EBD (Electronic Brake Distribute) is still working, so not a issues for normal soft braking. :thumbsup:

ABS Light up, mostly cause by electrical problem, DIY: chk fuse, remove and put it back to reset (make sure that the engine is OFF).

After washing with strong spray could cause some electrical short in sensor, water is good conductor.

Navigation

[0] Message Index

[*] Previous page