Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

reset ecu

(1/3) > >>

alghojo:
I have tried resetting the ecu using this method, found here http://forum.thelatioclub.org/index.php/topic,6305.0.html

1. Ignition "ON", count to 3.
2. Depress/Release pedal 5 times...hard and fast.
3. Count to 10 (not 7!) and fully depress pedal
4. Count to 12 (SES should be blinking), release pedal
5. Count to 10, depress pedal
6. Count to 10, release pedal.
7. Turn off ignition, then start engine. Done!

On step 4, the SES is blinking. The SES still blinking while going thru step 5 & 6. Was my reset successful?

crusty69:

--- Quote from: alghojo on January 16, 2011, 09:35:50 PM ---I have tried resetting the ecu using this method, found here http://forum.thelatioclub.org/index.php/topic,6305.0.html

1. Ignition "ON", count to 3.
2. Depress/Release pedal 5 times...hard and fast.
3. Count to 10 (not 7!) and fully depress pedal
4. Count to 12 (SES should be blinking), release pedal
5. Count to 10, depress pedal
6. Count to 10, release pedal.
7. Turn off ignition, then start engine. Done!

On step 4, the SES is blinking. The SES still blinking while going thru step 5 & 6. Was my reset successful?

--- End quote ---

u shld keep on pressing acc pedal until the CEL stops blinking
once CEL stops blinking then start ignition

alghojo:
ok noted, will try again

speedster:
at which step should the crl stop blinking?  :confused1:

crusty69:
at step 4, after pressing the acc pedal for a couple of seconds, the CEL will blink.
Continue pressing the acc pedal until the CEL becomes steady again.
After tat, release pedal and turn on ignition.

Navigation

[0] Message Index

[#] Next page