Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio

reset ecu

<< < (2/3) > >>

alghojo:

--- Quote from: crusty69 on January 17, 2011, 02:18:54 PM ---at step 4, after pressing the acc pedal for a couple of seconds, the CEL will blink.
Continue pressing the acc pedal until the CEL becomes steady again.
After tat, release pedal and turn on ignition.

--- End quote ---

so to say, dont need to release the pedal at 12 sec? just press till it stop blinking?

crusty69:
yup

alghojo:
if tats the case, step 5 & 6 no need to do?

crusty69:
yup

alghojo:

--- Quote from: crusty69 on January 17, 2011, 02:18:54 PM ---at step 4, after pressing the acc pedal for a couple of seconds, the CEL will blink.
Continue pressing the acc pedal until the CEL becomes steady again.
After tat, release pedal and turn on ignition.

--- End quote ---

 tried to reset again and this time after the CEL blinks, it does not becomes steady but instead it stops and blink a bit faster and repeat itself. I cannot make the blink steady. any comment?

Navigation

[0] Message Index

[#] Next page

[*] Previous page