« previous next »
Pages: [1]   Go Down

Author Topic: How to soften volume of reverse sensor?  (Read 4130 times)

Offline Panerex

  • Cool Engine (0 rpm)
  • Posts: 24
  • Car Color: red
How to soften volume of reverse sensor?
« on: September 09, 2013, 06:00:34 AM »
As topic above.
 How can I DIY,instead of gng back to tan Chong to obtain help?

TIA
Logged

Offline jonpaul0104

  • Mid Zone (3000 rpm)
  • ***
  • Posts: 525
Re: How to soften volume of reverse sensor?
« Reply #1 on: September 09, 2013, 10:01:36 AM »
as far as I have checked with TCM 8yrs back, it is not possible to adjust the voulme....
Logged

Offline kelvin

  • Commercial Moderator
  • Low End (2000 rpm)
  • *****
  • Posts: 386
  • Car Color: silver
Re: How to soften volume of reverse sensor?
« Reply #2 on: September 09, 2013, 10:13:13 PM »
If u could locate the buzzer,paste a tape over it,this will soften the tone..... :thumbsup:
Logged

Offline Panerex

  • Cool Engine (0 rpm)
  • Posts: 24
  • Car Color: red
Re: How to soften volume of reverse sensor?
« Reply #3 on: September 09, 2013, 11:00:54 PM »
Noob here. Care to share where stock reverse sensors buzzer would be located?

Thanks
Logged

Offline kelvin

  • Commercial Moderator
  • Low End (2000 rpm)
  • *****
  • Posts: 386
  • Car Color: silver
Re: How to soften volume of reverse sensor?
« Reply #4 on: September 10, 2013, 06:55:40 PM »
different installer will placed it in different location
Logged
Pages: [1]   Go Up
« previous next »