Nissan Car Lounge - Almera, Juke, Latio, Qashqai, Sylphy, Teana Owners > Latio
Rubber for lock/unlock button on doors
LatioR:
--- Quote from: vortex on February 05, 2009, 01:52:22 PM ---Maybe can go to the show room and 'take' a sample. :devil2:
--- End quote ---
As long as not to take from other lations, that will be Good :thumbsup:
clarence:
How about sourcing from workshops for those Latio doors damaged in accidents?
I am sure the rubber would still be intact.
vortex:
For temporary solution to prevent water from seaping through, maybe want to try using blu tack to cover. But then to prevent the blu tack from stucking into the hole, maybe have to press the button from the passenger door. :ohmy:
Why not try other TCM branch to get the rubber piece ?
Gone with the wind:
You can try to use the cling film, those transperant thin film that used for covering up the food to wrap around the handle. Can easily get the film from supermart.
May be you can email to Nissan Japan and question them why the rubber button came out and why they do not sell just the rubber button alone? Normally, the manufacturer is more responsive and they might even instruct TCM to change for you free.
Give it a try!
Jazz:
--- Quote from: vortex on February 06, 2009, 12:19:05 PM ---For temporary solution to prevent water from seaping through, maybe want to try using blu tack to cover. But then to prevent the blu tack from stucking into the hole, maybe have to press the button from the passenger door. :ohmy:
Why not try other TCM branch to get the rubber piece ?
--- End quote ---
But blue tack will deform after you pressed it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version